Swatchbook rolls out Mix 2.0 update
Mix 2.0 should also allow users to recolour materials on the fly with a new recolouring tool
Read More
DEVELOP3D
RAEng Ingenious Award winners announced
Aims to promote projects designed to inspire the next generation of engineers
Read More
Stratasys to push out new 3D Printing materials across AM platforms
16 new materials across three of its 3D printing technologies
Read More
Are you a pandemic start-up? Here’s what you need to know about IP
Expert William Miles offers guidance on protecting your ideas and adding value to your new company
Read More
Zortrax Z-PEEK meets ESA’s outgassing requirements
Z-PEEK now cleared for spaceflight with resistance to radiation, abrasion and high temps
Read More
Substance 3D Designer 12.1 adds new nodes for patterns and textures
A wide range of nodes to give users greater control
Read More
Fortify launch new 3D printing materials for wireless infrastructure market
New filled resins 'best-in-class materials' for electronics and RF applications
Read More
Altair Simulation 2022 bolsters electronics capabilities
Focus on next-gen connectivity, as well as circuit board and electronics design capabilities
Read More
Cura 5.0 from Ultimaker fine tunes the details
Enhanced slicing engine adds finer details and faster 3D prints
Read More
DirectFEM acquired by Hyperganic for quasi-mesh-less simulation
First public software from Hyperganic launches this summer
Read More