Structur3d Ultimaker 3D prints enable custom rubber parts Posted by DEVELOP3D - February 22, 2021 Injects industrial-grade liquid materials into 3D-printed moulds
MakerBot Method X Review Posted by Al Dean - December 4, 2020 From its heated build chamber to its bullet-proof accuracy, this is not the MakerBot of old
Raise3D E2 Review Posted by Al Dean - December 3, 2020 Continues the trend for large capacity FDM with some fancy new tricks up its sleeve
Ultimaker 2+ Connect adds internet to print anywhere Posted by DEVELOP3D - November 10, 2020 Added WiFi and ethernet connectivity adds remote 3D printing capability and simpler installation
Formlabs Form 3 Review Posted by Al Dean - December 3, 2020 Introduction of Low Force Stereolithography only adds to the ability of Formlabs' new 3D Printer
Enverter launched for dimensional analysis & unit conversion Posted by DEVELOP3D - September 24, 2020 A dimensional analysis and unit conversion software for engineering and scientific calculations
Kimya 3D printing filaments now available in UK Posted by DEVELOP3D - September 7, 2020 The French company is turning towards performance 3D materials having already specialised in inks and coatings
3D Printing tips for Ultimaker S5 and Cura 4 Posted by Al Dean - August 5, 2020 Boost your Ultimaker S5 by digging into some of the advanced and experimental options inside Ultimaker Cura
Buttoned-up use for recycled Marine Plastic Posted by Stephen Holmes - July 8, 2020 Made using Marine Plastic from Cornish fishing nets, buttons are sustainable, low carbon and local
In-house vac-forming pimps PlayDude’s packaging powers Posted by Stephen Holmes - May 14, 2020 Cost effective method for short-run, custom blister pack with a pro finish